The Dazor UV Retrofit Fixture
Note: Popup blockers can block the shopping cart.
Request Direct Product Ordering
Light curing of fiberglass resins, putties, fillers and gel coats eliminates the waste of catalyzed materials, and provides extended working time for layup and smoothing surfaces prior to curing. The cure cycle is in complete control, initiated only when light is applied.
While HID sources are usable to deliver the desired cure light, these sources require start up time, and cannot be turned on and off as needed due to long re-strike times. The result is exposure of delicate glass bulbs being run, with their associated heat, which is hazardous in tight project and manufacturing environments.
LEDs offer the advantage of instant on that can be switched off at any time and restarted instantly. LED sources also generate a fraction of the heat of HID sources, and do not rupture if exposed to sudden movements or shock. LEDs also generate only the light energy needed, with no waste light that is not needed for curing..
All Tasca UV cure lights incorporate LEDs a wavelength ideal for activation of most photo-initiators used in commercial resins. Tasca products are constructed to deliver long service life, which includes thermal control components to operate the LEDs at their lowest possible temperature to extend their life.
Tasca Light Cure LED products are Made in the USA by hand, and fully tested prior to shipment to insure each product works perfectly out of the box, and for years of reliable service. We also support all Tasca products with service, rebuilds and repairs to protect our customers investment.
This desk lamp has been converted from its original fluorescent lamp to a dual-purpose task and UV cure light. It incorporates white light with limited blue light content for use in preparing for a cure cycle, plus a 27 LED array for completing a UV cure cycle. In the task light mode, it delivers over 150 foot-candles of white light (3000K @ 90CRI). In the UV cure mode it produces over 35mW/CM²at 6” (20mW/CM² @10”) for perfect curing of small projects up to 14” x 17” in size. The fixture head incorporates fan cooling to allow extended cure cycles or long periods of use as a task light.
For more on how this retrofit was built and why, visit our blog at: Re-purposed Dazor LED Task and UV Cure Light
© Lumenique, llc. All rights reserved